DURKOPP ADLER 745-34-2 - Corner Knife Adjustments

5.5 Corner knife adjustments
The corner knives are adjusted by means of machine-specific
adjustment and test programs.
The procedure is described in the instruction manual
“Part 4: Programming Instructions DAC Cl. 745-34-2”
The following adjustments have to be made:
·
Check the corner knife adjustment
See Programming Instructions, chapter 7.3.5
·
Check the corner knife distance
See Programming Instructions, chapter 7.3.5.1
·
Check the left front corner knife
See Programming Instructions, chapter 7.3.5.2
·
Check the left rear corner knife
See Programming Instructions, chapter 7.3.5.3
·
Check the corner knife motion
See Programming Instructions, chapter 7.3.5.4
·
Machine parameters corner knives
See Programming Instructions, chapter 7.3.5.5
In this program the individual corner knives can be adjusted to the
seam beginning and to the seam end.
3
73