Mount the complete thread catcher
–
Mount the complete thread catcher on the machine head.
–
Mount the complete thread catcher in such a way that the needle
thread catcher 3 is centric between the needles.
–
Adjust the height of the thread catcher so that the dimension
between sliding sheet and lower edge of the needle thread catcher
is 27 +/- 1 mm.
–
Put on the guard plate 8.
The guard plate 8 has to be adjusted in such a way that the
distances of 1 mm and 0.5 mm are kept when the center knife is in
the lower dead center.
–
Tighten the guard plate 8 with the screws 7.
47
3
To Next Page
Loading...
