15.6.2 Position of the assembly strip on the rest table
Caution: Danger of injury !
Switch off the main switch.
Adjust the position of the assembly strip only with the main switch
turned off.
Standard
The position of the assembly strip 3 has to be adjusted in such a
way that the gripping needle rows stick into the center of the sponge
rubber 2. Make sure that the pocket bag is not clamped by the loading
angle 4.
Correction
Loosen counternut 5.
Turn the piston rod 6 correspondingly.
Ti ghten counternut 5.
Correction of the table
Slightly loosen the counternuts 1.
Adjust the table.
Ti ghten the counternuts 1.
If necessary, bring the table in parallel position.
140
43 2 1
65
To Next Page
Loading...
