Operation
Operating Instructions 867-M PREMIUM - 00.0 - 02/201524
Fig. 6: Threading procedure for needle thread - part 2
10. Guide the thread under the hook (10).
11. Insert the thread from bottom to top through the hole on the
thread regulator (15).
12. Insert the thread from the right to the left through the thread
lever (16).
13. Insert the thread through the upper thread guide (11).
14. Insert the thread through a hole in the lower thread guide (12).
15. Insert the thread through the thread guide on the needle bar
(13).
16. Insert the thread through the needle eye (14) in such a way
that the loose thread end faces the hook.
Short thread
cutter
17. For machines with a short thread cutter:
Pull the thread through the needle eye (14) until the loose
thread end - with the thread lever (16) in the highest position -
has a length of approx. 4 cm.
Important: Check the thread length.
If the thread end is too long,
the short thread cutter does not
function correctly.
(10) - Hook
(11) - Upper thread guide
(12) - Lower thread guide
(13) - Thread guide on the
needle bar
(14) - Needle eye
(15) - Thread regulator
(16) - Thread lever
To Next Page
Loading...
Need help?
General
