Settings via the software
Operating Instructions 867-M PREMIUM - 00.0 - 02/201578
8.6.3 Creating a program by teach-in
1. Press the Teach-In key.
2. Set the parameters for the step (stitch length, thread tension,
sewing foot pressure and sewing foot stroke).
3. Press the pedal and complete the seam section up to the
desired position on the material.
4. To set other parameters for another seam section, use to
add a new seam section.
5. Set the parameters.
6. Repeat steps 4 and 5 to define up to 30 steps if necessary.
7. Press the pedal back.
The program switches to Edit mode.
8. If necessary, add other parameters for all seam sections
(bartack, sewing speed, thread cutter, sewing foot lifter, etc.).
9. Press the ESC key.
The program is saved.
The machine switches to Automatic mode.
The program that was just created is selected.
8.6.4 Editing programs
1. In Automatic mode, press the P key.
The controller switches to Edit mode.
The program previously selected can now be edited.
The following information is shown on the display, and the P
in the program number field flashes:
Fig. 53: Display in Edit mode
1. Use / and / to select the program to be edited and the
step.
The selected step is shown bold in the program bar.
To Next Page
Loading...
Need help?
General
