DURKOPP ADLER 967 - Adjusting the Drive Pulley

Setting the drive
26
Service instructions 967 - 00.0 - 12/2014
6.1.2 Adjusting the drive pulley
Correct setting
Irrespective of which side of the drive pulley (2) is being used, there is a
difference in height of 16 mm between the faces of the two pulleys.
Figure 17: Adjusting the drive pulley
Setting steps
1. Loosen the screws (3).
2. Pull the drive pulley (2) off the motor shaft and put it back on the other
way round.
3. Adjust the difference in height between the faces of the drive pulley (2)
and the driven pulley (1) so that it is 16 mm.
4. Tighten the screws (3).
WARNING
Risk of injury
Switch off the sewing machine before checking and setting the
drive pulley.
(1) - Driven pulley
(2) - Drive pulley
(3) - Adjusting screws
཰
ཱ
ི
16 mm
16 mm