DURKOPP ADLER 967 Service Instructions

Position of the hook and needle
52
Service instructions 967 - 00.0 - 12/2014
10.2 Adjusting the dead point of the reciprocating movement
of the drive
Correct setting
The driver is at the dead point at 155°.
Cover
• Upper right cover ( page 12).
• Tilt the upper section ( page 10).
Figure 35: Dead point of the reciprocating movement of the drive
Setting steps
1. Loosen the screws (2).
2. Turn the eccentric (1).
3. Tighten the screws (2).
4. Check that the dead point (3) is at 155°, adjust it if again necessary.
(1) - Eccentric
(2) - Screws
(3) - Dead point
཰
ཱ
ི

DURKOPP ADLER 967 Specifications

General

Brand	DURKOPP ADLER
Model	967
Category	Sewing Machine
Language	English