Working basis
Service instructions 967 - 00.0 - 12/2014
9
3 Working basis
3.1 Sequence of the settings
The setting positions for the sewing machine are interdependent.
Always adhere to the specified sequence for the individual setting steps.
Always observe all information on requirements and following settings
marked at the side with .
3.2 Cable routing
Ensure that all cables in the machine are laid such that moving parts are
not impaired in their ability to function correctly.
1. Lay any excess cabling neatly in proper cable loops.
2. Tie the loops together using a cable tie.
If possible, bind the loops to fixed parts.
The cables must be fixed firmly in place.
3. Cut off any protruding part of the cable tie.
ATTENTION
Machine damage possible due to incorrect sequence.
Always adhere to the working sequence specified in this manual.
ATTENTION
Machine damage and malfunctions can be caused by laying the
cables incorrectly.
Excess cabling may obstruct moving machine parts in their ability to
function correctly. This will affect the sewing function and may cause
damage.
Lay excess cabling as described above.
To Next Page
Loading...
Need help?
General
