Setting the feed dog
40
Service instructions 967 - 00.0 - 12/2014
8.1.1 Moving the feed dog
Cover
• Throat plate ( page 15)
Figure 27: Moving the feed dog on the feed dog carrier
Setting steps
1. Loosen the screws (3).
2. Move the feed dog (1) on the feed dog carrier (2).
Place the removed throat plate next to it as an aid for orientation so that
the feed dog can be screwed on straight.
3. Tighten the screws (3).
8.1.2 Moving the feed dog carrier
The feed dog carrier is connected to the stitch regulator gear via the sliding
shaft and can be moved on this shaft.
Cover
• Tilt the upper section ( page 10)
(1) - Feed dog
(2) - Feed dog carrier
(3) - Screws
ཱ
ི
To Next Page
Loading...
