About these Service Instructions
4
Service Instructions 967 - 02.0 - 12/2015
Information
Additional information, e.g. on alternative operating options.
Sequence
Specifies the work to be performed before or after a setting.
References
Reference to another section in these instructions.
Safety Important warnings for the machine users are specially designated. Since
safety is of particular importance, hazard symbols, levels of danger and
their signal words are described separately in section 2 Safety.
Orientation If the figure is unclear, indications of right or left are always from the user's
point of view.
1.3 Other documents
Some of the machine's built-in components have been made by third-party
manufacturers. Each manufacturer has performed a hazard assessment
for these purchased parts and confirmed their design compliance with ap-
plicable European and national regulations. The proper use of these com-
ponents is described in each manufacturer's instructions.
1.4 Liability
All information in these service instructions was compiled with consider-
ation to the state of the art, and applicable standards and regulations.
Dürkopp Adler cannot be held liable for damages resulting from:
• Breakage and damage during transport
• Failure to follow the operating instructions
• Improper use
• Unauthorized modifications to the machine
• Use of untrained personnel
• Use of unapproved replacement parts
To Next Page
Loading...
Need help?
General
