Adjusting the sewing foot feed
62
Service Instructions 967 - 02.0 - 12/2015
Cover
• Arm cover ( p. 11).
• Head cover (
p. 12)
.
Fig. 43: Aligning the feed stroke of the feet
Setting steps
1. Put the handwheel into the 0° position ( p.
20).
2. Set stitch length to 0.
3. Adjust the zero stroke of the feet ( p. 59).
4. Loosen the screw (5).
5. Take the plate (3) out of its working position (4), turn it around and place
it under the feet as illustrated so that the sewing foot (2) is 0.3 mm lower
than the presser foot (1).
6. Manually move both feet down as far as they will go.
7. Tighten the screw (5).
11.4 Setting the stroke movement for the feeding foot
(1) - Presser foot
(2) - Sewing foot
(3) - Plate
(4) - Working position of the plate (3)
(5) - Screw for the lever used to raise the
feet
①
②
③
④
⑤
WARNING
Risk of injury!
Risk of crushing injuries and stab wounds from
sharp
and moving parts.
Switch the machine off before you check and set
th
e stroke movement for the feeding foot.
To Next Page
Loading...
