Machines with integrated motor
90 Service Manual 867 Version 02.0 - 04/2015
Removing
the stator
Fig. 74: Removing the stator
1. Undo all three screws (1).
2. Remove the cover plate (2).
3. Remove the stator with ring (3).
Removing
the rotor
Fig. 75: Removing the rotor
1. Remove the arm cover.
2. Undo all four threaded screws (1, 2).
3. Remove the rotor with deep groove ball bearing (2).
(1) - Screws
(2) - Cover plate
(3) - Stator with ring
②
①
③
(1) - Threaded screw
(2) - Threaded screw
(3) - Rotor with deep groove ball bearing
①
②
③
To Next Page
Loading...
