Dymo MimioClassroom - Conducting a Teacher-Led Activity; Asking Questions Using Quick Vote

Using the Vote Toolbar
n Viewing Question Results
n Viewing Session Results
n Viewing a List of Students that Have Not Responded
Conducting a Teacher-Led Activity
Once you have created an activity in Notebook or PowerPoint
®
,you can perform the activity
with your class. When performing a Teacher-Led activity, the questions are displayed one at
a time for the students.
You can ask questions that you did not previously create in Notebook or PowerPoint at
any time during a Teacher-Led activity using MimioStudio Quick Vote.
To conduct a teacher-led activity
1. Open the Notebook or PowerPoint presentation that contains the activity you want to
conduct.
2. Select the class that will participate in the activity from the Class list.
3. (Required for PowerPoint only.) Set the display to Full Screen or Slide Show view.
4. Display the first question for the class.
5.
Click on the Vote Toolbar to start polling for the question.
In Notebook, you can also start and stop polling directly from the question object
by clicking .
When all students have responded, polling for the question stops and the results are
saved to the Gradebook.
6.
To stop polling for a question before all students have responded, click .
Polling stops and the results are saved to the Gradebook.
7. Repeat steps 4-6 for each remaining question in the activity.
8. When all questions in the activity have been answered, close the presentation and the
Vote Toolbar to stop the activity.
Asking Questions Using Quick Vote
Using the MimioStudio Quick Vote, you can ask questions that you did not previously
create in Notebook or PowerPoint at any time during a Teacher-Led activity.
To ask a question using Quick Vote
1. Do one of the following to start Quick Vote:
l
Right-click , and then choose Quick Vote.
l
(Interactive mode Only) Press the Launch button, , on the MimioTeach bar, and
then click Quick Vote.
2. Select the class that will participate in the activity from the Class list.
3.
Click , and then choose the question type to start polling for the question.
When all students have responded, polling for the question stops.
4.
To stop polling for a question before all students have responded, click .
5. Click the letter that corresponds to the correct answer for the question.
The results for the current question are saved to the Gradebook along with a screen
shot.
109