Customizing MimioStudio
3. Click Combine.
The Create extended surface dialog box appears.
4. Choose the arrangement of your combined surfaces from the Extend Surface Styles list.
5.
Press the New Page button, , on each MimioCapture tray, in the order shown.
6. Enter a name for your extended surface in the Extend Surface Name box and click OK.
You can combine up to four different surfaces.
To create a combined surface (Mimio Interactive)
1. Connect two or more Mimio Interactive devices to your computer.
2. Set the surface size for each Mimio Interactive device.
3. Click Combine.
The Create extended surface dialog box appears.
4. Choose the arrangement of your combined surfaces from the Extend Surface Styles list.
5.
Press the New Page button, , on each Mimio Interactive bar, in the order shown.
6. Enter a name for your extended surface in the Extend Surface Name box and click OK.
You can combine up to four different surfaces.
To view device information
Click Settings.
The dialog box appears showing the device information, environmental analysis, and
device memory.
To reset to the default device settings
Click Defaults.
Adjusting the Interactive Settings
The Interactive settings allow you to calibrate or enable (if calibration has already been
done) Interactive mode. The Interactive settings also contain settings for changing the
functions of the MimioTeach stylus, Mimio Interactive mouse, MimioTeach bar,
MimioCapture tray buttons, and Mimio Interactive bar buttons.
General Settings
Setting Description
Use previous calibration Prevents you from having to calibrate each time you start Interactive
mode.
Select this setting if you have a permanently installed whiteboard and
projector.
Automatically enable
when a device is
detected
Automatically starts Interactive mode when a MimioTeach or Mimio
Interactive bar is connected to your computer.
136
To Next Page
Loading...