MimioTeach
Cleaning MimioTeach
MimioTeach is designed to give you long and trouble-free service while requiring very little
maintenance.
You can easily clean your MimioTeach using the following items:
n Lint-free cloth.
n Isopropyl alcohol, diluted dishwashing detergent, or diluted glass cleaner.
If you use glass cleaner, make sure it does not contain ammonia.
To clean the MimioTeach bar and stylus
1. Disconnect the USB cable from the MimioTeach bar.
2. Use the lint-free cloth to wipe the exterior of the MimioTeach bar and stylus.
3. Remove dirt and smudges with one of the cleaning solutions mentioned above.
Avoid using liquids on any exposed charging contacts. Do not allow liquid into
any openings on the equipment.
4. Reconnect the USB cable.
Inserting the Batteries
MimioTeach is powered using the included USB cable and power adapter. Optionally,
MimioTeach can be powered using three AAA batteries.
To insert the batteries
1. Press down and slide off the battery compartment cover.
2. Insert three AAA batteries into the battery compartment.
3. Replace the battery compartment cover.
Remove the batteries if the MimioTeach bar will not be used for a long period of time.
Mounting MimioTeach to a Non-Magnetic Whiteboard
The MimioTeach bar attaches securely to any magnetic whiteboard. If you do not have a
magnetic whiteboard, you can mount the MimioTeach bar to your whiteboard using the
included metal plates.
If you are installing both MimioTeach and MimioCapture, you must mount
MimioCapture before mounting MimioTeach. This will ensure proper placement of the
MimioTeach bar. See Mounting MimioCapture to a Non-Magnetic Whiteboard for
information on mounting MimioCapture.
To mount MimioTeach to a non-magnetic whiteboard
1. Place the metal plates against the back of the MimioTeach bar as shown.
Make sure that the recess on each plate is inserted into the recess on the back of the
MimioTeach bar.
46
To Next Page
Loading...