GBK51948 RHINO2
Installation Manual Issue 5
Low acceleration values give a softer performance and a less sensitive throttle response.
High acceleration values give a more aggressive performance and a fast throttle response.
Note
This parameter cannot be set higher than the value of the Acceleration Limit parameter that has been set by the
scooter manufacturer.
6.5.3.3 Forward Deceleration
Parameter
Possible
Values
Default HHP Lite Std Adv
Forward Deceleration 0 - 100 %
See Parameter
Variations
✓ ✓ ✓ ✓
Sets how quickly the scooter slows down after the throttle has been released from forward
deflection to neutral.
0 % — From full forward speed, the scooter stops in 10s
100 % — From full forward speed, the scooter stops in 0.4s
Figure 50: Deceleration characteristics
Low deceleration values produce a gentle stop but increase the braking distance. High
deceleration values produce a more aggressive stop but can be uncomfortable. Adjust this
parameter to the preference of the user.
Note
This parameter cannot be set higher than the value of the Deceleration Limit parameter that has been set by the
scooter manufacturer.
Warning
Setting Forward Deceleration too low or too high can result in a scooter that is unsafe. Test thoroughly after
programming to make sure that the scooter complies with local regulatory requirements for maximum
allowable braking distance.
Page 84 - Programming
To Next Page
Loading...
Need help?
General
