Eaton EASY-E4 Series - Page 601

On the CI incremental encoder 237
Online Catalog 587
Operands
Assigning 158
Assigning, function block output 159
Deleting at function block inputs/outputs 159
Operating frequency 285, 294
Operating hours counter 188
Operating hours counter for visualization device 188
Operating mode 91, 259, 274, 279, 397, 403
Timing relay 197
Operating modes
Change not recognized (NET) 573
Operating sequence
Pulse output 293
Operation
Proper 31
Original Operating Instructions 2
OT 188
OT - Operating hours counter for visualization
device 188
P
P buttons 142, 357
Package contents 40
Parameter setting 359
Parameters
Enabling/disabling access 156
Part number 25
Password
Assigning 477
Changing 478
Enabling 478
Forgotten 478
Period duration 267
Period duration to minimum ON duration ratio 270
PID controller 272
Operating mode 272
PID Controller
Scan time 272
Plausibility check 448
PO
Jog mode 285
Normal mode 287
Pulse output 284
PO - Pulse output 284
Ports 61
Program cycle time 275
Program name 472
Programming method
User function block 435
Proportional actuators 267
Proportional factor 279
Proportional gain 279
Proportional gain Kp 274
Proportional term 273
PT 342
PT1 signal smoothing filter 279
Pulse duration 267
Pulse output 267
PO - Pulse output 284
Pulse sequence 267
Pulse shape of counter signals 237
Pulse width 267
Pulse width modulation 267
PUT 342
PW 267
Q
Q01/Q02 267
Q1 (boolean function block output) 188, 244, 339
PT - "PUT" Network 342
easyE4 11/18 MN050009 EN www.eaton.com
597