3. Commissioning
3.5 Establishing an Ethernet connection and transferring a program or visualization project
Upload the programs and visualization project files
To rebuild a project, you can upload the *.e80 program from the easyE4 base device,
the visualization project, and the configuration of the devices back to easySoft 8 by
clicking on Device => PC. To do this, you can connect to the first NET station and
start the upload for multiple easyE4 base devices simultaneously. To complete this
information, you will then have to connect to the relevant easyE RTD Advanced visu-
alization device and upload the visualization project and the device configuration to
the PC.
See also
 → Section "Connecting the Ethernet cable", page 91
 → Section "Establishing an Ethernet connection", page 185
easyE402/24 MN050009ENEaton.com
123
To Next Page
Loading...
Need help?
General