Eaton easyE4

4. Operation
4.6 Transfer program to the easyE4 device
The Card setup dialog box will appear.
easySoft 8 Project View\Project\Card...
Fig. 91: Card setup dialog box
You can use the Card section to specify the storage location, i.e., the drive, where the
microSD memory card is located.
In addition, this section will show the available information about the memory card.
Click on the PC => Card button to select the transfer option you want.
The File selection dialog box will appear.
182
easyE402/24 MN050009ENEaton.com