Eaton easyE4

6. Function blocks
6.1 Manufacturer function blocks
BC11 +
>I1
>I2
> NO
Fig. 209: Parameters on the display
Enter the function block settings here. The display contains the following elements:
BC11 block
compare
Function block: Data block comparator, number 11
+
Parameter set can be called via the PARAMETERS menu
>I1
Start of comparison range 1; the data block with the start address present
at input I1 is compared with the data block with the start address present at
input I2.
>I2
Start of comparison range 2
> NO
Number of elements to be compared in bytes per range, number: 1 - 383
See also
 → Section "BT - Block transfer", page 418
 → Section "DB - Data function block", page 424
 → Section "MX - Data multiplexer", page 429
 → Section "RE - Recipe records ", page 433
 → Section "SR - Shift register", page 439
 → Section "TB - Table function", page 447
easyE402/24 MN050009ENEaton.com
417