netconf -h
Usage:netconf[OPTION]...
Display network information and change configuration.
-h,--helpdisplayhelppage
-l,--landisplayLinkstatusandMACaddress
-d,--domaindisplayDomainmode,FQDN,PrimaryandSecondaryDNS
-4,--ipv4displayIPv4Mode,Address,NetmaskandGateway
-6,--ipv6displayIPv6Mode,AddressesandGateway
Setcommandsareusedtomodifythesettings.
-s,--set-lan<linkspeed>
Linkspeedvalues:
autoAutonegotiation
10hf10Mbps-Halfduplex
10ff10Mbps-Fullduplex
100hf100Mbps-Halfduplex
100ff100Mbps-Fullduplex
1000ff1.0Gbps-Fullduplex
-f,--set-domainhostname<hostname>setcustomhostname
-f,--set-domain<mode>
Modevalues:
-setcustomNetworkaddress,NetmaskandGateway:
manual<domainname><primaryDNS><secondaryDNS>
-automaticallysetDomainname,PrimaryandSecondaryDNS
dhcp
-i,--set-ipv4<mode>
Modevalues:
-setcustomNetworkaddress,NetmaskandGateway
manual<network><mask><gateway>
-automaticallysetNetworkaddress,NetmaskandGateway
dhcp
-x,--set-ipv6<status>
Statusvalues:
-enableIPv6
enable
-disableIPv6
disable
-x,--set-ipv6<mode>
Modevalues:
-setcustomNetworkaddress,PrefixandGateway
manual<network><prefix><gateway>
-automaticallysetNetworkaddress,PrefixandGateway
router
Examples of usage:
-> Display Link status and MAC address
netconf-l
-> Set Auto negotiation to Link
netconf--set-lanauto
-> Set custom hostname
netconf--set-domainhostnameups-00-00-00-00-00-00
-> Set Adress, Netmask and Gateway
netconf--set-ipv4manual192.168.0.1255.255.255.0192.168.0.2
-> Disable IPv6