Eaton Network-M2 - Page 119

Settings
Contextual help of the web interface – 119
•
•
•
•
•
•
3.7.6.1 Modbus RTU
The following Modbus RTUsettings are configurable:
Enable
Baud rate
Parity
Stop bits
3.7.6.2 Modbus TCP
The followingModbus TCPsettings are configurable:
Enable
Port
This section is only for the Modbus Network ModuleINDGW
For instructions on connecting Modbus RTU see the sectionInstalling the Network Management
Module>>>Wiring the RS-485 Modbus RTU terminal>>>Configuring the termination.
For instructions on configuring Modbus see the section
Installing the Network Management Module>>>Configuring Modbus
.