Edimax CAP1300 - Page 172

Edimax Pro NMS
172
You can edit AP Groups from the NMS Settings  Access
Point page.
IP Address
Assignment
Select “DHCP Client” for your access point to be assigned a
dynamic IP address from your router’s DHCP server, or select
“Static IP” to manually specify a static/fixed IP address for
your access point (below). Check the box “Override Group
Setting” if the AP is a member of an AP Group and you wish to
use a different setting than the AP Group setting.
IP Address
Specify the IP address here. This IP address will be assigned to
your access point and will replace the default IP address.
Subnet Mask
Specify a subnet mask. The default value is 255.255.255.0
Default
Gateway
For DHCP users, select “From DHCP” to get default gateway
from your DHCP server or “User-Defined” to enter a gateway
manually. For static IP users, the default value is blank.
Primary DNS
DHCP users can select “From DHCP” to get primary DNS
server’s IP address from DHCP or “User-Defined” to manually
enter a value. For static IP users, the default value is blank.
Secondary
DNS
DHCP users can select “From DHCP” to get secondary DNS
server’s IP address from DHCP or “User-Defined” to manually
enter a value. For static IP users, the default value is blank.
IGMP
Snooping
Enable / Disable the IGMP Snooping function.
IGMP snooping is the process of listening to Internet Group
Management Protocol (IGMP) network traffic.
Location Type
Select the location of the AP (indoor or outdoor).
X-5-1-1-2 Edit Web Account Settings
When “Override Group Setting” is checked, options/fields will turn white to
allow adjustments.