Edimax CAP1300 - Page 337

337
- <Parameter>
{media} 2.4g Set the interval between transmission of 802.11g.
5g Set the interval between transmission of 802.11a.
(num) Set the transmission interval. (1~255)
- <Default configuration>
1
- <Command mode>
Immediate Mode, Edit Mode, Reference Mode
- <Compatible Products>
CAP1300
- <Examples>
# wlan 5g beacon dtim 100
wlan {2.4g | 5g} beacon interval
Configure the transmission interval of the beacon.
<The syntax of the command>
wlan {media} beacon interval (num)
- <Parameter>
{media} 2.4g Configure the interval between transmission of 802.11g.
5g Configure the interval between transmission of 802.11a.
(num) Set the transmission interval. (20~1000 ms)
- <Default configuration>
100
- <Command mode>
Immediate Mode, Edit Mode
- <Compatible Products>
CAP1300
- <Examples>
# wlan 5g beacon interval 200
wlan {2.4g | 5g} channel change_ch_if_STA_connected
Set the change channel function of this product. (The station is connected status.)
<The syntax of the command>
wlan {media} channel change_ch_if_STA_connect {disable | enable}
- <Parameter>
{media} 2.4g Set the function enable or disable on 802.11g.
5g Set the function enable or disable on 802.11a.
- <Default configuration>
Disable
- <Command mode>
Immediate Mode, Edit Mode
- <Compatible Products>
CAP1300
- <Examples>
# wlan 2.4g channel change_ch_if_STA_connect enable