AP, Managed AP, Repeater & Client Bridge Modes
37
Changing Date and Time
1. Go to “Management” > “Date and Time”.
2. Set the correct time and time zone for your access point using the drop
down menus. The access point also supports NTP (Network Time
Protocol) so, alternatively, you can enter the host name or IP address of
a time server. Click “Apply” when you are finished.
You can use the “Acquire Current Time from your PC” button if you wish
to set the device to the same time as your PC.
The basic settings of your access point are now configured.
To Next Page
Loading...
