© Edwards Limited 2015. All rights reserved. Page 101
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
M588-00-880 Issue E
Appendix A2 Pump display terminal
The PDT accessory provides pump on/off and status reporting. Warnings and alarms are also indicated to the user.
Up to two PDTs may be fitted.
Figure A41 - Pump display terminal
A2.1 LEDs
LOCAL CONTROL green illuminates continuously when this PDT has control of the pump.
PUMP ON green (within the pump start button) illuminates to indicate that the pump is running. The
LED illuminates continuously when the pump is on-process and flashes when the pump is warming up,
stopping or when it is in Green Mode/Standby mode.
WARNING yellow illuminates to indicate that a pump warning is present. It flashes when a new warning
occurs until it is acknowledged by pressing ENTER when it goes continuous until the warning clears. The
warning LED also flashes when a new event is present. Once the event has been acknowledged the
warning LED will return to its previous state.
ALARM red illuminates to indicate that a pump alarm is present. It flashes when a new alarm occurs
until it is acknowledged by pressing ENTER when it goes continuous until the alarm clears.
To Next Page
Loading...
