© Edwards Limited 2015. All rights reserved. Page 123
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
M588-00-880 Issue E
The following menus are used by the PDT to configure dry pump clean:
Figure A49 - Dry pump clean PDT menu configuration items
A2.9.1 Changing the dry pump speed during the clean operation
Use the Set DP speed menu item to change the dry pump speed during the clean cycle. It is not recommended to
increase the pump speed if solvent is used. If the dry pump clean is just using air then setting the speed to 110 Hz
would increase the efficiency of the cleaning cycle.
To Next Page
Loading...
