M588-00-880 Issue E
Page 106 © Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
Press the UP/DOWN keys to select the new settings and press ENTER to accept or CANCEL to exit back to the Set
sequences menu.
A2.4.5.1 Warm up options menu
Scroll by pressing UP/DOWN keys. Press ENTER to open a sub menu or CANCEL to exit back to the Set sequences
menu.
Press the UP/DOWN keys to select enable / disable and press ENTER to accept or CANCEL to exit back to the Warm
up options menu.
Dry Pump Clean DP Clean… See Dry Pump Clean menu
Allow pump to go on-process
when in Warning
WarnOnProcess… Enable/Disable
Ramped speed up on-process OnProcessRamp… See on-process Ramp menu
PID Pressure control setup PID… See PID menu
Smart Shutdown Smart Stop… See Smart Stop menu
Speed Control options Speed Control... See Speed Control menu
Reset MicroTIM Reset MicroTIM... See Reset MicroTIM menu
Restore factory defaults Default Reset... See Default Reset menu
Table A9 - Warm up options menu
Option Text on PDT line 2
Options on PDT line 2 after pressing Enter (use
up/down arrow to change, enter to select)
Warm-up Temperature set point Setpoint temp… Range 0-210 °C
*
*
Scroll through the temperature options by pressing the UP/DOWN keys. Press ENTER to accept the new
setting. Press CANCEL to exit back into the Warm up options menu.
Auto Green Mode Auto Green Mode… Enable/Disable
Allow Cold on-process ColdOnProcess… Enable/Disable
Inlet purge on during warm-up Inlet Purge… Enable/Disable
Automatically re-warm when in
Green Mode
Auto Rewarm… Enable/Disable
Table A8 - Set sequences menu (continued)
Option Text on PDT line 2
Options on PDT line 2 after pressing Enter (use
up/down arrow to change, enter to select)
To Next Page
Loading...
