© Edwards Limited 2015. All rights reserved. Page 59
Edwards and the Edwards logo are trademarks of Edwards Limited.
Service, spares and accessories
M588-00-880 Issue E
7 Service, spares and accessories
7.1 Introduction
Note: The oil must not be drained from the dry pumping system. It must be clearly stated that the pump is full
of oil when completing the HS2 form.
Edwards products, spares and accessories are available from Edwards companies and distributors world-wide. These
centres employ Service Engineers who have undergone comprehensive Edwards training courses. Order spare parts
and accessories from the nearest Edwards company or distributor. When ordering, please state for each part
required:
1. Model and Item Number of the equipment.
2. Serial Number (if any).
3. Item Number and description of the part.
7.2 Service
Edwards products are supported by a world-wide network of Edwards Service Centres and distributors. Each Service
Centre offers a wide range of options including: equipment decontamination; service exchange; repair; rebuild and
testing to factory specifications. Equipment that has been serviced, repaired or rebuilt is returned with a full
warranty. The local Service Centre can also provide Edwards engineers to support on-site maintenance, service or
repair of the equipment. For more information about service options, contact the nearest Service Centre or other
Edwards company.
Edwards can provide training, tooling and spares to enable users to overhaul their dry pumping systems.
Remove pump accessories before returning the dry pumping system for service.
When returning the dry pumping system to an Edwards Service Centre or other Edwards company,
the requirements of Section 7 and of the Return of Edwards Equipment Procedure (refer to forms
HS1 and HS2 at the rear of this manual) must be complied with.
To Next Page
Loading...
Need help?
General
