© Edwards Limited 2015. All rights reserved. Page 133
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
M588-00-880 Issue E
A2.12.1 Using SIM protocol through Ethernet
The SIM Ethernet protocol is available on the following TCP/IP Ports
Use an Ethernet cable to connect to the Ethernet interface (Figure 3, item 3) and then set the IP address of the
system to the correct address.
Note: If changing the IP address of a system or connecting/disconnecting an Ethernet cable, it may take several
minutes before the GXS responds on its Ethernet port.
When the GXS system is configured to use DHCP addressing the PDT can be used to read the pump's current IP address.
The Setup menu to display this is shown below.
Figure A55 - Setup menu items
To check that communication with the GXS is working, use the ping command from a command prompt on the
computer. It is important that the GXS and the computer are able to route signals to each other, for example they
should be on the same subnet. If in doubt contact the computer support department for advice.
Example of ping to a pump:
Figure A56 - Ping to a pump screenshot
Table A26 - SIM protocol
SIM TCP/IP Port
1 47591
2 47592
To Next Page
Loading...
