© Edwards Limited 2015. All rights reserved. Page 109
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
M588-00-880 Issue E
A2.4.5.7 PID menu
Scroll by pressing UP/DOWN keys. Press ENTER to open a sub menu or CANCEL to exit back to the Set sequences
menu.
Press the UP/DOWN keys to select enable / disable and press ENTER to accept or CANCEL to exit back to the PID
menu.
A2.4.5.8 PID parameters menu
Scroll by pressing UP/DOWN keys. Press ENTER to open a sub menu or CANCEL to exit back to the PID menu.
For each digit press the UP/DOWN keys to set the digit then press ENTER to accept and move to the next digit or
CANCEL to move back to the previous digit. Pressing ENTER at the end of the line will accept the new setting.
Pressing CANCEL at the start of the line will cancel and exit back to the PID parameters menu.
Table A14 - PID options menu
Option Text on PDT line 2
Options on PDT line 2 after pressing Enter (use
up/down arrow to change, enter to select)
PID enable/disable Enable/Disable… Enable/Disable
Pressure setpoint Target Pressure Range 1 to 10000 Pa
*
*
For each digit press the UP/DOWN keys to set the digit then press ENTER to accept and move to the next
digit or CANCEL to move back to the previous digit. Pressing ENTER at the end of the line will accept the
new setting. Pressing CANCEL at the start of the line will cancel and exit back into the PID menu.
PID operating mode Operating mode... Manual/Automatic
PID Tuning Parameters PID Parameters… See PID Parameters menu
Gauge used for PID PID Gauge... Active Gauge/Auxiliary Gauge/Pressure (4-20 mA)
Table A15 - PID parameters options menu
Option Text on PDT line 2
Options on PDT line 2 after pressing Enter (use
up/down arrow to change, enter to select)
Time constant Time Constant… Range 0.01 - 10 seconds
Proportional constant KC… Floating point number
Integral constant Ti… Floating point number
Differential constant Td… Floating point number
To Next Page
Loading...
