M588-00-880 Issue E
Page 104 © Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
A2.4.3 Setup menu
Press the SETUP button to enter. Menu title is shown at the top of the display. Scroll by pressing UP/DOWN keys.
Press ENTER to open a sub menu or CANCEL to exit back to Normal menu.
Each sub menu is described below.
Booster speed in percent MB SPEED 100 %
Booster speed in Hz MB SPEED 100 Hz
Dry pump inverter temperature DP INV TEMP 100 C
Booster inverter temperature MB INV TEMP 100 C
Exhaust pressure EXHAUST 5 PSI
Exhaust temperature EXH PIPE TEMP 100 C
Water flow rate WATER 11.1 l/m
Run hours RUN HOURS 1000
Number of pump starts PUMP STARTS 100
Time to stop (seconds) TIME TO STOP 900
Active alarms and warnings
Solvent soak SOLVENTSOAK Off
Dry pump clean DP CLEAN Off
Active strain gauge ASG 3.4E+01 mbar
PT100 temperature PT100 1 108 C
Pressure transducer PR 105.0 kPa
PID Auto tune status PID TUNE Normal
Table A5 - PDT setup menu structure
Description Display
Commands menu
*
*
This option requires a security code to access it
Command Menu…
Set sequences menu
*
Set Sequences…
Display Inverter Fault History menu Inv Fault Hist…
Software Version Display menu S/W Version…
Display Serial Number Serial Num…
Fit Accessory menu
*
Fit Accessory…
Edit IP configuration menu IP Config…
Edit Display Attributes menu Display Attr…
Set Time and Date Set Clock…
Display Pump Type Show pump type…
Table A4 - Typical display (continued)
Description Typical display
To Next Page
Loading...
