© Edwards Limited 2015. All rights reserved. Page 125
Edwards and the Edwards logo are trademarks of Edwards Limited.
Appendix A2
M588-00-880 Issue E
The PDT menus for speed control are shown in Figure A50.
Figure A50 - Speed control menu items
A2.10.1 Normal speed
The full speed settings for the booster and dry pump are set by Edwards when the pump is manufactured. If a lower
full speed is required then this can be set using a downloadable configuration. Configurations can be downloaded
using the Edwards Configuration Download Utility (CDU). Please contact Edwards application specialists to discuss
your requirements.
By default, dry pump and booster speed control are set to normal, meaning that the pumps will run at their
configured full speeds.
To Next Page
Loading...
