Edwards GXS 160 - Page 17

© Edwards Limited 2015. All rights reserved. Page 5
Edwards and the Edwards logo are trademarks of Edwards Limited.
Introduction
M588-00-880 Issue E
Figure 3 - The controls/connectors on the rear of the pump (system with rear exhaust and castors/levelling feet
fitted)
1. Ethernet LAN LED (green)
2. Ethernet link LED (yellow)
3. Ethernet connection
4. Power LED (green)
5. System interface (PDT & serial SIM)
6. Warning LED (yellow)
7. Running and alarm LEDs (2 colours, either
green or red)
8. Accessory interface
9. MicroTIM in control LED (green)
10.Pneumatic valve inlet connection (if fitted)
11.DP clean solvent flush fluid connection (if
fitted)
12.High flow purge air filter (if fitted)
13.Cooling water in
14.Auxiliary gauge or pressure input connection
(if fitted)
15.Protective Earth (ground) stud
16.Purge gas rotameter
17.Cooling water out
18.Purge gas connection
19.RF Earth (ground) stud
20.Exhaust gas outlet connection
21.Levelling foot (if fitted)
22.EMS interface
23.MicroTIM connection (if fitted)
24.Electrical supply connector
25.Electrical connector locking mechanism