M588-00-880 Issue E
Page 26 © Edwards Limited 2015. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Installation
The pump and booster combination systems have an interspool which has several ports that can be used for leak
checking purposes. Remove the right hand side panel and refer to Figure 6.
Note: For further information on leak testing, contact the supplier or Edwards for advice.
Leak test the dry pumping system after installation and seal any leaks found to prevent leakage of
dangerous substances out of the dry pumping system and leakage of air into the dry pumping
system.
To Next Page
Loading...
