EFI Pro 24f - 6 Printing on the EFI Pro 24 F; Standard Printing Procedure; Start up Printer

Document ID: OMM-00148 Rev. B
58
6.0 Printing on the EFI Pro 24f
This chapter covers the process for printing on the EFI Pro 24f, including the steps for standard print jobs, conducting a daily
white print, printer workflows, full-bleed printing, centering a print on the media, skipping blank space to increase print
speeds, and methods for printing multiple rigid media boards.
6.1 Standard Printing Procedure
Use the following steps to conduct a standard print job on the EFI Pro 24f.
6.1.1 Start Up Printer
1. Load the media. (See section 5.3 or 5.3.)
2. Launch the EFI Print Control Utility.
Figure 6-1: EFI Print Control Utility
1
2
3. Click the “Tools” or “Gear” button.
Note: Either butto
n opens the EFI Pro 24f Control window.
1Tools: Perform maintenance 2 Gear: Adjust print settings
4. Click the “Moon” icon on the EFI Pro 24f Control window to bring the printer out of sleep mode.