Leakage Voltage & Current Recording Configuration
Both voltage & current PQZIP channels recording must be enabled in order to support
leakage current channels as illustrated below.
In case the PQZIP recording is enabled while change is applied, it is advised to disable it
and then enable it again.
Enable/Disable leakage voltage PQZIP recording
Enable/Disable leakage current PQZIP recording
NOTE NOTE NOTE
PQSCADA supports leakage PQZIP channels from version 4.3.0.25 and above. Therefore the
PQSCADA server must be upgraded as well if this feature is required.
To Next Page
