Sequence Parameters
121
User Guide
Version 4.1
r
try out different pitches in order to match the vocal range of a
singer.
You can transpose the entire song by selecting Edit > Select All,
and then changing the transposition value for every sequence
in one operation.
If no sequence has been selected, then Transpose will influ-
ence the parwert
settings, which will affect all subsequent recordings, and what
you hear when you play into Logic fun.
With drum tracks, transposing influences the triggered drum notes, usually causing
the wrong sounds to be triggered. For this reason, you should leave out the drum
tracks when transposing an entire section of a song.
Velocity
With the Velocity paramete,r you can increase or decrease the
velocity value of selected sequences. The value range goes
from -99 to +99.
Please note that you cannot go above or below the possible
values of 0-127, as defined in MIDI. If, for example, the notes
in a sequence have velocity values between 100 and 120, then
the setting +60 will only have the effect of raising everything to
the possible maximum of 127.
If no sequence is selected, Velocity will influence the -MIDI
THRU-setting.
Delay
With the Delay parameter, you can move selected sequences by
small increments, forward or backward in time. The measuring
units here are clock ticks, which represent a 3840
th
fraction of a
measure in Logic fun. If you set a negative value, the affected
To Next Page
Loading...