Event List Structure
165
User Guide
Version 4.1
r
Counting begins at 1 for each unit (first bar, first beat, first divi-
sion, first tick: 1 1 1 1), and continues until it is carried over to
the next largest unit.
Numerical inputs start from the left (which means you can
enter just the bar number if you want). The units can be sepa-
rated by either spaces, dots, or commas.
Status
This is where you can see the event type, as specified by the
status byte of a MIDI message. You cannot directly edit this
parameter.
Cha
The MIDI channel used to record an event.
Remember that during playback this MIDI channel will be
replaced by the Cha parameter of the playback instrument. The
event is only output to the recorded MIDI channel when the
Cha parameter is set to All.
Num, Val
These columns contain event data bytes. Their meaning
depends on the event type:
Length/Info
With controller events, this column shows the controller name.
Status Num Val
Note Pitch Velocity
Control Controller number Value
Pitch LSB MSB
C-Press (not used) Value
P-Press Pitch Value
Program Bank Select Program number
Hint
To Next Page
Loading...