Emagic Logic fun - Resetting Parameters; 10.2 the MIDI Channel Strips

146
Chapter 10
Mixer and Effects
Emagic
Logic fun
Resetting Parameters
Clicking a parameter while holding O (Mac) or ç (PC) resets
the parameter to a standard value. This is 100 with MIDI
volume faders and 90 with audio faders, or 64 (center) with pan
and balance. The standard value for the Sends is 0dB (90).
10.2 The MIDI Channel Strips
These are the parameters of the MIDI channel strips used to
remotely control the mixing functions of your MIDI sound
modules, for any MIDI modules that support these functions.
This is the case with all sound modules or sound cards that
show the General MIDI, GS- or XG-logos, as well as with the
vast majority of more recent multi-timbral MIDI sound gener-
ators with integrated effect processors.
•
2 effect sends or
•
2 other types of Controller- or NRPN-messages;
•
128 pre-set patch locations for GM standard sounds
•
Bank select commands
•
pan
•
volume (with the fader).
The MIDI channel strips have “LEDs“ that will light up green
when note messages are being sent, and yellow, when control-
ler messages are sent.
Try the following:
•
Open the Tutorial Song and start playback.
A piano can be heard on Channel 1.
•
Move Fader 1 (click and drag the mouse).
The piano will become either softer or louder as the Fader is
moved.