126
Chapter 7
Arrange Window
Emagic
Logic fun
Regulating the volume with the Controller 7 should not be confused with a conven-
tional volume change. Here—independent from your amplifier and mixer—the
internal volume, controlled through MIDI is set to its maximum value.
Resetting the Controllers
With Options > Send to MIDI> Reset Controllers, “neutral”
controller data is sent to all sound modules. Use this when a
controller is stuck, or left in the wrong state, causing the tone
generator to sound differently than it should..
This can happen when, for example, you push pause in the
middle of a song and then start up again at another spot, or
when you make the song position line jump to another position
by clicking on it in the bar ruler.
To Next Page
Loading...