The Display Parameter Box
195
User Guide
Version 4.1
r
Automatic Display of Triplets
When a binary display quantization value is used, triplets will
not be displayed at all. Therefore a “hybrid“ quantization value
must be chosen for the Qua parameter, to enable the proper
display of triplets.
Default Setting
Unlike in older versions of Logic fun, the Qua cannot be set to
default in already existing sequences. The default option can
only be used in the Insert Defaults (see above) which determine
the default settings for newly recorded or created sequences. If
default is chosen there, the Qua setting of any new sequence
will depend on the Global Display Value in the Transport
window. In this case, the Qua value will always be the hybrid
value which contains the global display value currently set in
the Transport window plus—in case of a binary global value—
the next higher ternary value or—in case of a ternary global
value—the binary value which is divided by that particular
ternary value.
A few examples: A global value of 1/8 will result in an 8,12 Qua
setting for new sequences, global value 1/12 will become Qua =
4,12, global value 1/16 will result in Qua = 16,24, 1/24 in 8,24
and so on.
However, if a particular Qua value has already been set in the
Insert Defaults (which are displayed in the Display Parameter
Box whenever no sequence is selected), all new sequences will
be assigned this value, regardless of the Global Display Value in
the Transport window. Any of these values can be changed after
recording.
12 1/8-note triplets
24 1/16-note triplets
48 1/32-note triplets
“Qua” Setting Corresponding Note Length
To Next Page
Loading...