Emerson DL8000 - Page 305

DL8000 Preset Instruction Manual
Revised February-2016 DL8000 Keypad Display E-87

14/03/12 12:26:02
Test AI Ch
Use AO Ch
(SELECT)
AI ch 1
AO ch 1
Note: For an external source, select NONE.
 14/03/12 12:26:02
Test AI Ch
Use AO Ch
(SELECT)
AI ch 1
NONE
Press ENTER to proceed. The system displays the AI EU value range
(high and low values) and the AO EU value range (high and low
values). This enables you to define a signal within the valid range.

14/03/12 12:26:02
Test AI Ch
Use AO Ch
AI EU value range ->
AO EU value range ->
(ENTER to continue)
AI ch 1
AO ch 1
0.000 to 100.000
0.000 to 100.000
EXIT to Go Back
Note: If you are using an external resource for analog input, the system
displays only the AI EU value range:

14/03/12 12:26:02
Test AI Ch
Use AO Ch
AI EU value range ->
(ENTER to continue)
AI ch 1
AO ch 1
0.000 to 100.000
EXIT to Go Back
If you press ENTER, the screen enables you to provide a value for the
selected AI channel. You can also enter different values for the AO
current value. The system changes the AI current value in response.
(Press EXIT to redisplay the analog input selection screen.)