I/O Type: +5V Encoder Power
Circuit Type: +5V Power with Electronic Short Circuit Protection
Output Voltage: 4.70 v to 5.20 v at 0.5 amp
Output Current: 0.5 amp max (total for all connectors)
Notes:
Note: This output is intended to power external devices such as Incremental Quadrature Encoders
requiring less than 0.5 amps total from all four axis connectors. The output current is provided by
the host controller backplane +5v supply and is protected by an electronic short circuit protector
in the DSM314 module.
The total external device current drawn from this +5V circuit must be added to the power supply
consumption value in the DSM314 configuration screen in the configuration software and must
be added in if performing a manual power supply loading calculation.
The listed 0v pin should normally be used as the power return signal.
To Next Page
Loading...
