Emerson DSM314 - 3.3 I;O Wiring and Connections

User Manual Chapter 3
GFK-1742F Jan 2020
Installing and Wiring the DSM314 54
High Capacity Series 90-30 Power Supplies
•
IC693PWR330 - High Capacity AC/DC Power Supply - allows 30 watts (6000 mA) for
+5 VDC
•
IC693PWR331 - High Capacity 24 VDC input Power Supply - allows 30 watts (6000
mA) for +5 VDC
•
IC693PWR332 – High Capacity 12 VDC input Power Supply - allows 30 watts (6000
mA) for +5 VDC
Note: If you are installing the ground plate on a painted surface, the paint must be removed where the
ground plate is to be mounted to ensure a good ground connection between the plate and
mounting surface.
Note: Refer to GFK-0867B, (Emerson Product Agency Approvals, Standards, General Specifications), or
later version for product standards and general specifications.
Installation instructions in this manual are provided for installations that do not require special
procedures for noisy or hazardous environments. For installations that must conform to more
stringent requirements (such as CE Mark), see GFK-1179, Installation Requirements for
Conformance to Standards.
3.3 I/O Wiring and Connections
3.3.1 I/O Circuit Types
Each of the module’s four connectors (Connector A, B, C, and D) provide the following types
of I/O circuits:
•
Three differential / single ended 5v inputs (IN1-IN3)
•
5 VDC Encoder Power (P5V)
•
One single ended 5v input (IN4)
•
Four single ended 5v input / output circuits (IO5-IO8)
•
Three 24v inputs (IN9-IN11)
•
One 24v, 125 mA solid state relay output (OUT1)
•
Two differential 5v line driver outputs (OUT2-OUT3)
•
One 24v, 30 mA solid state relay output (OUT4)
•
Two differential +/- 10v Analog Inputs (AIN1-AIN2)
•
One single ended +/- 10v Analog Output (AOUT1)
Not all of these I/O circuits are available for user connections. Some of the circuits are used
to control the digital servo amplifier. Refer to Tables 3-11 through 3-14 for additional
information.