User Manual Chapter 3
GFK-1742F Jan 2020
Installing and Wiring the DSM314 56
Figure 33: Axis and Auxiliary Terminal Board Assemblies
Note: Each terminal board is shipped with DIN Rail mounting feet. Instructions for converting a terminal
board to panel-mount are included in this chapter.
3.3.3 Digital Servo Axis Terminal Board - IC693ACC335
Description
The IC693ACC335 Digital Servo Axis Terminal Board is used to connect the DSM314 to
Digital Servo Amplifiers. The board contains two 36-pin connectors, labeled DSM and
SERVO. A cable IC693CBL324 (1 meter) or IC693CBL325 (3 meters) connects from DSM
connector (PL2) to the DSM314 faceplate connector A or B. A Servo Command Cable
IC800CBL001 (1 meter) or IC800CBL002 (3 meters) connects from the SERVO connector
(PL3) to the JS1B connector on a
Series or
Series Digital Servo Amplifier.
Eighteen screw terminals are provided on the Digital Servo Axis Terminal Board for
connections to user devices. These terminals have the following assignments:
To Next Page
Loading...
