Emerson DSM314 - Control (CTL) Bits

User Manual Chapter 4
GFK-1742F Jan 2020
Configuration 105
Note: Since this Serial Communications Port is used only for upgrading the DSM314’s firmware, it is
recommended you leave this port’s communications settings at their default values. Use cable
IC693CBL316 to connect this port to the serial port of a personal computer running the firmware
upgrade software.
4.3.4 Control (CTL) Bits
The CTL Bits configuration tab allows the user to configure the input source for Control Bits
(CTL01-CTL24). The configuration screen allows the user to select a CTL bit configuration
that corresponds with Motion Program and Local Logic program requirements. CTL Bits
configuration parameters are described in Table 30. For additional information concerning
CTL bit configuration, consult chapter 14.
Table 30: CTL Bits Tab
Configuration Parameter
Description
Default
Ref
CTL01 Config
CTL01 Bit Configuration
IN9_A (Axis 1 +OT)
Chapter 14
CTL02 Config
CTL02 Bit Configuration
IN10_A (Axis 1 -OT)
Chapter 14
CTL03 Config
CTL03 Bit Configuration
IN11_A (Axis 1 Home Sw)
Chapter 14
CTL04 Config
CTL04 Bit Configuration
Strobe1 Level (Axis 1)
Chapter 14
CTL05 Config
CTL05 Bit Configuration
IN9_B (Axis 2 +OT)
Chapter 14
CTL06 Config
CTL06 Bit Configuration
IN10_B (Axis 2 -OT)
Chapter 14
CTL07 Config
CTL07 Bit Configuration
IN11_B (Axis 2 Home Sw)
Chapter 14
CTL08 Config
CTL08 Bit Configuration
Strobe1 Level (Axis 2)
Chapter 14
CTL09 Config
CTL09 Bit Configuration
%Q bit Offset 12
Chapter 14
CTL10 Config
CTL10 Bit Configuration
%Q bit Offset 13
Chapter 14
CTL11 Config
CTL11 Bit Configuration
%Q bit Offset 14
Chapter 14
CTL12 Config
CTL12 Bit Configuration
%Q bit Offset 15
Chapter 14
CTL13 Config
CTL13 Bit Configuration
IN9_C (Axis 3 +OT)
Chapter 14
CTL14 Config
CTL14 Bit Configuration
IN10_C (Axis 3 -OT)
Chapter 14
CTL15 Config
CTL15Bit Configuration
IN11_C (Axis 3 Home Sw)
Chapter 14
CTL16 Config
CTL16 Bit Configuration
Strobe1 Level (Axis 3)
Chapter 14
CTL17 Config
CTL17 Bit Configuration
%Q bit Offset 24
Chapter 14
CTL18 Config
CTL18 Bit Configuration
%Q bit Offset 25
Chapter 14
CTL19 Config
CTL19 Bit Configuration
%Q bit Offset 40
Chapter 14
CTL20 Config
CTL20 Bit Configuration
%Q bit Offset 41
Chapter 14
CTL21 Config
CTL21 Bit Configuration
%Q bit Offset 56
Chapter 14
CTL22 Config
CTL22 Bit Configuration
%Q bit Offset 57
Chapter 14
CTL23 Config
CTL23 Bit Configuration
%Q bit Offset 72
Chapter 14
CTL24 Config
CTL24 Bit Configuration
%Q bit Offset 73
Chapter 14