Emerson DSM314 - H-4 Connecting to and Storing Your Configuration to the PLC

User Manual Appendix H
GFK-1742F Jan 2020
Using VersaPro with the DSM314 474
H-4 Connecting to and Storing Your Configuration
to the PLC
Note: You cannot store your configuration file to the PLC from within the configurator program. You
must be on VersaPro’s Main LD screen in order to store to the PLC.
Useful Tool Bar Icons
Several toolbar icons will be used in the next several steps to initiate such operations as
Connect, Stop the PLC, and Store. The following figure identifies these toolbar icons:
Figure 230: VersaPro Toolbar Icons
Connecting to the PLC
•
On the main VersaPro screen, click the Connect icon on the Toolbar. The Connect
dialog box will appear.
Figure 231: The Connect Dialog Box
•
If connecting directly to the PLC programmer port from the COM1 serial port on your
computer, use the DEFAULT settings shown in the figure above.