User Manual Chapter 3
GFK-1742F Jan 2020
Installing and Wiring the DSM314 55
3.3.2 Terminal Boards
•
Axis Terminal Board, Catalog No. IC693ACC335 – Used in digital mode only. It
connects DSM connector A or B to a
or
Digital Servo amplifier. It also provides
screw terminal connections for I/O devices. This terminal board contains two 36 pin
connectors. One connects to the DSM via cable IC693CBL324/325, and the other
connects to the Digital Servo amplifier via the servo command cables IC800CBL001
/ 002. See Figures 40, 46, 47, and 48.
Note: For Digital Servo applications that do not require use of the DSM’s A or B connector I/O signals,
the DSM connector can be cabled directly to the digital servo amplifier. Refer to Section 3, “I/O
Wiring and Connections,” later in this chapter for additional information.
•
Auxiliary Terminal Board, Catalog No. IC693ACC336 – This terminal board contains
a single 36 pin connector that connects to the DSM314 module. This board has two
basic applications (see Figures 40 and 41):
1.
For Analog servos, it connects to DSM Connector A, B, C or D to provide screw
terminals for wiring to a third-party Analog servo amplifier and I/O devices. See
Figures 49 through 53.
2.
For Auxiliary axes, it connects to DSM Connector B, C, or D to provide screw
terminals for wiring to external devices such as Strobe sensors, Home switches,
and Overtravel Limit switches. Note: See Figure 53.
•
SL-Series Servo to APM/DSM Terminal Board, Catalog IC800SLT001 – Used to
connect DSM connector A, B, C or D to a SL-Series analog velocity interface servo
amplifier, as well as provide screw terminals for wiring to I/O devices. It contains two
connectors. One connects to the DSM module, and the other to the SL-Series Servo
amplifier. For additional information, please see the SL-Series Servo User’s Manual,
GFK-1581.
Table 15: DSM Terminal Board Quick Selection Table
To Next Page
Loading...
