User Manual Chapter 8
GFK-1742F Jan 2020
Follower Motion 234
The diagram below illustrates the three DSM314 analog axes connected in parallel with
Commanded Position for Axis #4. The reader should note that with this configuration, the
Local Logic function cannot be run. This is because the command generator for axis #4 is
required for this configuration. The Master Source Configuration items are all set to
Commanded Position Axis #4. This is not a requirement. However, it does eliminate a source
of error due to the master source select bit being set incorrectly.
Figure 105: 3-Axis Analog Follower / Parallel Structure / Source = Commanded
Position 4
To Next Page
Loading...
